tag:blogger.com,1999:blog-3079411123321019478.post4414764859383372284..comments2024-01-23T12:41:44.446+00:00Comments on The Caffeinated Engine Driver: Half a SleeperMarkhttp://www.blogger.com/profile/02418527698793489162noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-3079411123321019478.post-83428558080127323892021-05-07T08:06:01.622+01:002021-05-07T08:06:01.622+01:00I don't see why not. I'm sure I've see...I don't see why not. I'm sure I've seen the printed brass used as an attachment for a lighter to burn symbols into wood. You could probably also sharpen the ends of the pins slightly to make them start a hole rather than force their way in -- I can't do that in the model as the sharp point wouldn't print.Markhttps://www.blogger.com/profile/02418527698793489162noreply@blogger.comtag:blogger.com,1999:blog-3079411123321019478.post-56014773611429061392021-05-04T20:56:00.989+01:002021-05-04T20:56:00.989+01:00I think it would work better it heated up and burn...I think it would work better it heated up and burnt into the sleeper, as otherwise the holes seem more like eye slots, as the tool presses between the grain, rather than punching a round hole... would that work? James Hhttps://www.blogger.com/profile/09612994249392438901noreply@blogger.comtag:blogger.com,1999:blog-3079411123321019478.post-88616073607257305992021-05-04T13:22:49.155+01:002021-05-04T13:22:49.155+01:00Nice Mark. It does the job.Nice Mark. It does the job.Adrian Wardhttps://www.blogger.com/profile/09061432566298145837noreply@blogger.com