First up, there has been some work on the latest Clayton build. That photo may not look too impressive but the box the body parts are resting on holds a few more bits of work. I've now collected all the parts together to complete the build, and I've assembled the wheelsets and the main layshaft. Most of the work though has gone into preparing the 3D body prints. Normally I spray my models from an aerosol can which puts the paint on reasonably thickly and hides some of the print issues. I'm hoping though to move to using an airbrush for painting so that I don't end up hiding small details etc. and can have access to a wider range of colours. This means though that I need to spend more time preparing the model surfaces. So far both parts have had two rounds of rubbing down with 2000 grit sandpaper after being sprayed with Mr Finishing Surfacer 1500. It's the first time I've tried using this stuff and so far I'm impressed, although the proof will come when I apply a layer of primer.
And now for something completely different. I usually model in my study, unfortunately the desk is pushed up against a thin internal wall and on the other side is my son's cot, so doing much when he's asleep is tricky, and I've avoided doing too much modelling in the lounge after he's gone to bed due to the inevitable mess I'd make. I've especially avoided doing anything with metals and plastics that might leave nasty stray bits if I don't clean up properly. So wanting a project I could work on in the lounge after he was in bed, I've picked up a kit made mostly from wood. I'm not going to reveal what that is just yet but as a clue, I decided to scratch build a brake wheel for it.
No comments:
Post a Comment