Somewhere to Sit

One bit of detailing that you couldn't see in the previous post was the inside of the cab.

Now I know it's not the best of photos but hopefully you get the picture. As you can see I've retained the original brake stand and wheel from the kit, but the rest is all new. The kit originally had a flor cut to look like wooden planks which didn't seem to match any of the real locomotives so I switched this to some chequer plate. I was intending to use the seat that came in the kit as once the driver figure is in place you can't see it. I began to have second thoughts on this when I found it was a little tall and the roof wouldn't fit because the drivers head was too high. I was just going to trim the bottom of the parts to lower it down, but then discovered that I'd manage to loose one part of the seat. At this point I thought it was easier just to make a new one that more closely matched the real thing even if it will be completely hidden.

Oh and before anyone comments that the brake wheel is wonky, I know. I took the photo with the parts just resting together. When I glue it in place I'll make sure it's right.