Sunday, July 26, 2020

10HP Baguley: Step 7 (and Inadvertently Step 8)

So in theory we are now getting very close to the end of the instructions. As you can tell though given the gap since the last post in this sequence, not only have I been very busy with work, but things didn't entirely go to plan. Anyway here is the text of step 7 from the instruction sheet.

Fix the bonnet into place – in order for the front of the bonnet to sit flush with the front buffer beam, some material may have to be removed from the back of the tank where it fixes against the cab and the locating ‘pips’ into the running plate at the front of the bonnet may also need adjustment. Once the adhesive has cured/solder cooled, file back the locating pegs flush. Fix the sandboxes into place.
The bonnet is a whitemetal casting and usually I find these really annoying as by the time I've bought a kit the moulds are old and the parts need a lot of cleaning up. Of course with this being a new kit this isn't the case and the quality of the castings is superb. Just look at the detail and how square and clean the edges are... and yes this is before I did anything to the casting.


I didn't have to do much to the casting at all. The only thing I found was that the locating pins were a little big for the holes in the etched parts, but this was easily solved by opening up the holes ever so slightly and then the bonnet just dropped in and fitted perfectly.


As with the whitemetal casting used as part of the cab floor I choose to superglue it into place rahter than risk damaging it by trying to solder it. As you can see I couldn't resist fitting the chassis to check how the whole model was looking.

The next step was to fir the sandboxes which are also nice whitemetal castings. As with the bonnet I just had to open up the holes in the etch ever so slightly for them to just drop right into place.


Unfortunately after gluing them to the footplate I spotted one small problem. They overhang the hole in the footplate which means that the chassis no longer fits. I can't see that I did anything wrong fitting these so I'm not quite sure how this happened.


Either way a little bit of careful filing and I'd reduced their depth enough for the chassis to fit back inside the body.


By making sure the chassis fits it turns out that I'd also inadvertently completed step 8 as well as that reads

Gently offer up the chassis into the body, there is limited clearance and this will be a touch fiddly making sure the motor leads do not get trapped by the running plate. It must be noted that the 'live' side frames will be in close proximity to the body which could potentially cause a short. However, painting the body to form a good insulation should eliminate the issue.
Given how tight a fit everything is I'm absolutely certain that the body will be shorting out the chassis at this point so I have not tried running it yet, and won't until it's painted to avoid doing any damage.

In theory the next step should be adding a little filler and cleaning up all the joints before painting. Oh if life were only that simple!

2 comments:

  1. If you don't feel confident using paint for insulation, try brushable superglue. It's tougher and sticks to anything but still very thin. This is the trouble with tiny prototypes!

    ReplyDelete
    Replies
    1. Yes, I've got a bottle of Carr's Electrofix which I've never used but which I think might work well in this instance. I'm thinking of coating both the edges of the body before painting and the chassis itself. If that doesn't work though, superglue was next on my list.

      Funny story. I bought the Electrofix with some metal blackening solutions as I'd read that it would seal the finish, which it did. Unfortunately I was trying to age rails and they were now useless for powering locos.

      Delete