Tidy Wiring

So the very last task to finish off the chassis was to tidy up the wiring. Because of the way the motor slides into the body I had to be careful to keep the wires running close to the gearbox and motor side, which was achieved with a bit of masking tape, and then it was just a simple case of shortening the wires and soldering them to the motor to give this...

Of course with the wiring done and the chassis finished the obvious thing to do was to check that it still fitted into the body, and that the body didn't cause a short or rub anywhere that would cause an issue.

And to that the only thing I need to say is "sheer tea cufff, sheer tea cuff" (goodness knows how best to spell that but feel free to leave suggestions in the comments).